Page 108
REPAIR INSTRUCTIONS
87
Figure 87 — Fuel Filter Adapter Assembly (Early
Production)
Coolant Conditioner Element
Removal
[215 LD]
The following procedure applies for engines
equipped with a coolant conditioner. The coolant
conditioner is available as an option on current-
production engines.
Refer to Figure 88 and Figure 90.
1. Disconnect wiring harness leads at the
coolant temperature sensor on the coolant
manifold and the boost air temperature
sensor on the air inlet manifold. Position
leads out of way.
2. Disconnect fittings (3) from both ends of the
coolant conditioner supply tube. Remove
tube (2).
Remove only the supply tube. Do not remove the
brass elbow fittings at the manifold and the
cylinder block.
88
Figure 88 — Coolant Conditioner Supply Tube Removal
1. Fuel Filter Adapter
Assembly
2. Secondary Filter Fitting
(Out)
3. Secondary Filter Fitting
(In)
4. Capscrews
5. Primary Filter Fitting
(Out)
6. Primary Filter Fitting (In)
7. Air Inlet Manifold
8. Mounting Flange
1. Plastic Tie Wrap
2. Coolant Conditioner
Supply Tube
3. Fittings
5_106_00.bk Page 108 Friday, August 4, 2000 11:17 AM
BDC for engine manuals and specs