![background image](http://html1.mh-extra.com/html/mack/e-tech-sb-210-034/e-tech-sb-210-034_service-manual_3224387289.webp)
REPAIR INSTRUCTIONS
Page 273
The oil cooler and oil filter mounting bracket
assembly can be installed separately, but
assembling them together on a bench is easier
and reduces the possibility of damaging the
O-ring seals.
INSTALLATION PROCEDURE
Refer to Figure 302.
1. Lubricate the oil cooler supply tube (5) with
Vaseline
®
, or equivalent.
2. Position the coupling (4) over the lubricated
tube.
3. Place two clamps (3) over the coupling.
4. Place a gasket on the oil supply mounting
flange (11).
5. Position the oil cooler and oil filter mounting
adapter assembly on the engine. Slide the
coupling (4) over the thermostat housing
flange. Lubricate the threads of the
capscrews (10) and insert the capscrews
into the mounting flange. Do not tighten the
capscrews at this time.
6. Place a gasket on the water pump mounting
flange (2).
7. Lubricate the threads of the two mounting
capscrews (1) and insert the capscrews to
secure the oil cooler flange (2) to the water
pump. Tighten the capscrews to the
specified torque, 40 lb-ft (54 N•m), using
torque wrench J 24407, or equivalent.
8. Tighten the oil supply housing capscrews
(10) to the torque, 40 lb-ft (54 N•m), using
torque wrench J 24407, or equivalent.
9. Tighten the clamps (3) to the specified
torque, 38 lb-in (4.3 N•m).
10. Connect the oil hose (8) to the fitting (9).
11. Coat the threads of the oil sending unit (12)
with sealing compound and install the unit in
the oil filter adapter assembly (13).
5_106_00.bk Page 273 Friday, August 4, 2000 11:17 AM
BDC for engine manuals and specs