![background image](http://html1.mh-extra.com/html/mack/e-tech-sb-210-034/e-tech-sb-210-034_service-manual_3224387166.webp)
Page 150
REPAIR INSTRUCTIONS
142
Figure 142 — Rear Auxiliary Bushing Alignment
1. Clean the surfaces of the bushing and the
bore. Dry both surfaces with compressed air.
2. Using a dark-colored felt-tip marker, mark
the block and the bushing with a line (1) to
facilitate correct alignment during
installation. Refer to Figure 143.
3. Position the replacement bushing (2) against
the front face of the block at the front
bushing bore. Align the oil hole in the
bushing with the hole in the block.
143
Figure 143 — Auxiliary Shaft Bushing Alignment
4. Using camshaft bushing removal/installation
tool J 21428-01 (4) and the appropriate pilot
adapter (3), install the bushing.
5. Check the bushing surface for burrs caused
by installation.
6. After the bushing is in place, measure the ID
to ensure that the bushing is not undersize
because of burrs on the OD caused by
installation. Refer to the Fits and Limits chart
in the SPECIFICATIONS section in this
manual for the bushing ID dimensions.
1. Alignment Mark
2. Bushing
3. Pilot Adapter J 37713
4. Camshaft Bushing
Remover/Installer
(J 21428-01 Kit)
5_106_00.bk Page 150 Friday, August 4, 2000 11:17 AM
BDC for engine manuals and specs