![background image](http://html1.mh-extra.com/html/mack/e-tech-sb-210-034/e-tech-sb-210-034_service-manual_3224387170.webp)
Page 154
REPAIR INSTRUCTIONS
146
Figure 146 — Sleeve Installation
Clean any RTV from around the bottom of the
cylinder sleeve and the block which may have
been pressed out from the sealing surfaces of the
block and sleeve during installation.
6. After the cylinder sleeve is fully seated, use
depth gauge J 26948, or equivalent, to
check the flange height-above-deck
dimensions. The specified dimension is
0.023–0.029 inch (0.584–0.737 mm). The
measurement should be taken in the
channel between the sleeve top lip (fire
dam) and the coining bead. Refer to
Figure 147.
1. Sleeve
2. Shims (as Required)
3. Counterbore Ledge
4. Cylinder Block
5_106_00.bk Page 154 Friday, August 4, 2000 11:17 AM
BDC for engine manuals and specs