![background image](http://html1.mh-extra.com/html/mack/e-tech-sb-210-034/e-tech-sb-210-034_service-manual_3224387117.webp)
REPAIR INSTRUCTIONS
Page 101
Oil Cooler and Oil Filter Mounting
Bracket Assembly Removal
[215 DW, 219 EP]
If the engine is equipped with the plate-type oil
cooler, the cooler and oil filter mounting bracket
must be removed before mounting the engine in
the stand. The configuration of the housing
assembly protrudes into the area required for the
engine mounting adapter plate. The removable
bundle-type oil cooler and oil filter mounting
bracket does not protrude into the mounting area
and can remain on until after the engine is
mounted in the stand if desired.
PLATE-TYPE OIL COOLER AND OIL FILTER
MOUNTING BRACKET WITH INVERTED
TOP-MOUNTED CENTRI-MAX
®
PLUS
(Current Production)
Refer to Figure 79 and remove the assembly as
follows:
1. Disconnect the harness from the oil
pressure and oil temperature sensors
(6 and 5) on the filter mounting bracket (9).
2. Disconnect the turbocharger lubrication
supply line (2) from the mounting bracket.
3. Loosen the hose clamps at the cooler-to-
water pipe connection, and slide the hose
away from the cooler and further onto the
tube.
4. While supporting the oil cooler and oil filter
mounting bracket assembly with one hand,
remove the four capscrews (7) attaching the
oil cooler and oil filter mounting bracket to
the cylinder block (8).
5. Lift the oil cooler and oil filter mounting
bracket assembly off the block surface and
place on a clean work surface.
79
Figure 79 — Plate-Type Oil Cooler and Oil Filter Mounting Bracket Removal
1. Oil Supply Port (for Mechanical Dashboard Gauge)
2. Turbocharger Lubrication Supply Line
3. Oil Cooler
4. Oil Supply Port (for REPTO), Turbo Unloader and Remote-
Mounted Oil Filter
5. Oil Temperature Sensor Port
6. Oil Pressure Sensor
7. Mounting Bracket Capscrews (Four)
8. Cylinder Block
9. Oil Filter Mounting Bracket
5_106_00.bk Page 101 Friday, August 4, 2000 11:17 AM
BDC for engine manuals and specs