![background image](http://html1.mh-extra.com/html/mack/e-tech-sb-210-034/e-tech-sb-210-034_service-manual_3224387137.webp)
REPAIR INSTRUCTIONS
Page 121
Nozzle Holder Removal
[222 KG]
SPECIAL TOOL REQUIRED
r
Injection Nozzle Puller J 37093
After removing the nozzles, it is a good practice
to label or tag them for reinstallation into the
same cylinders. After removal, place nozzles on a
clean surface.
Refer to Figure 105.
1. Remove nozzle holder retainer (2).
2. Assemble injection nozzle puller J 37093 as
follows:
a.
Attach nut (12), bearing (11), spacer
(10) and rubber washer (9) to tool
handle (1).
b.
Screw handle (1) in threaded hole of
nozzle holder (5) until rubber washer
(9) is slightly compressed.
3. With tool in position, turn nut (12) clockwise
to draw nozzle holder from cylinder head
nozzle mounting hole (8).
4. Continue turning nut until nozzle holder is
free of insert. Remove nozzle holder and
puller tool as an assembly.
5. Remove nozzle holder gasket (7). The
gasket is manufactured from a special iron
material 0.060-inch (1.524 mm) thick.
6. Remove remaining nozzle holders in the
same manner.
105
Figure 105 — Nozzle Holder Removal
1. Handle
2. Nozzle Holder Retainer
3. O-Rings
4. Alignment Pin
5. Nozzle Holder
6. Nozzle
7. Gasket
8. Nozzle Mounting Hole
9. Rubber Washer
10. Spacer
11. Bearing
12. Nut
5_106_00.bk Page 121 Friday, August 4, 2000 11:17 AM
BDC for engine manuals and specs