![background image](http://html1.mh-extra.com/html/mack/e-tech-sb-210-034/e-tech-sb-210-034_service-manual_3224387121.webp)
REPAIR INSTRUCTIONS
Page 105
Alternator Removal
[271 CB]
Refer to Figure 83.
1. Loosen adjusting capscrew (1) and
mounting capscrews (2).
2. Remove the poly-v drive belt.
3. Disconnect and tag electrical wires.
4. Remove mounting nuts, washers and
capscrews (2), and remove alternator (3).
5. Remove mounting hardware and remove
alternator plate.
83
Figure 83 — Alternator Removal
Engine Electronic Control Unit
(EECU) Removal
[230 EA]
Left-Side Mounted Assembly
The following procedure applies for an EECU
mounted on the left side of the engine. The
procedure for a right-side mounted unit with
cooling plate is covered later in this section.
1. Thoroughly clean the area around the ECU
harness connector to make sure the
terminals remain clean for reassembly.
2. Disconnect the wiring harness to the EECU
(Figure 84).
84
Figure 84 — EECU Connector Removal
1. Adjusting Capscrew
2. Mounting Capscrews
3. Alternator
1. Upper Connector
2. EECU
3. Lower Connector
5_106_00.bk Page 105 Friday, August 4, 2000 11:17 AM
BDC for engine manuals and specs