Page 112
REPAIR INSTRUCTIONS
Air Inlet Manifold Removal
[214 HD]
The following procedure applies for both the
early-production engines (right-side mounted
EECU) equipped with a two-piece air inlet
manifold and current-production engines (left-
side mounted EECU) equipped with a one-piece
manifold.
Refer to Figure 91 and Figure 92.
1. Support the air inlet manifold and remove
12 capscrews (9) that secure the manifold
(6 and 8) to the cylinder heads.
2. Remove air inlet manifold. It may be
necessary to gently pry or tap the manifold
lightly with a soft mallet to break the seal.
3. If the air inlet manifold is to be replaced,
remove sensor (7) located on the inlet
manifold (6), if installed.
92
Figure 92 — One-Piece Air Inlet Manifold
Water Pump Removal
[215 SW]
Refer to Figure 93.
1. Disconnect coolant return hose to air
compressor (1) at fitting on water pump.
2. Remove three mounting capscrews (3) and
remove water pump (2).
93
Figure 93 — Water Pump Removal
1. Air Compressor Coolant
Return Line
2. Water Pump
3. Capscrew
5_106_00.bk Page 112 Friday, August 4, 2000 11:17 AM
BDC for engine manuals and specs