REPAIR INSTRUCTIONS
Page 139
11. Using hex key wrench PT2210-14 (18), turn
the cutter bit adjusting screw clockwise until
the cutter bit rests on the counterbore ledge.
12. If the cutter bit will not adjust, adjust the
lower depth-set collar (16) 0.005 inch
(0.127 mm) more and recheck cutter bit
hold-down screws for looseness.
13. Zero the depth-set collars:
a.
Back off the lower depth-set collar (16)
and carefully lower the cutter plate (13)
into the bore and allow the cutter to rest
on the counterbore ledge.
b.
Rotate both depth-set collars (5 and 16)
down until the bottom collar contacts
the main housing (8).
Do not force the collar beyond this point, as it will
lift the cutter plate and prevent an accurate zero
reading.
14. Set the depth of the cut. Determine the final
depth of the cut and back off the top depth-
set collar accordingly. Each increment on the
depth-set collar increases the depth of the
cut by one-thousandth (0.001) of an inch
(0.025 mm). Tighten the thumbscrew (17) on
the upper collar (5) securely.
5_106_00.bk Page 139 Friday, August 4, 2000 11:17 AM
BDC for engine manuals and specs
