Page 160
REPAIR INSTRUCTIONS
ROUND DOWEL PIN INSTALLATION
Refer to Figure 152.
1. Insert the round dowel pin (2) into the
flywheel housing/front cover locating pin
driver J 37712 (1). The pin must be
positioned in the driver with the tapered end
of the dowel facing outward.
2. Position the exposed end of the dowel into
the left dowel pin hole (4) in the cylinder
block (3).
3. Using a hammer, drive the pin into the block
until the driver contacts the cylinder block.
When the driver has made contact with the
block, the dowel pin will be at the correct
dimension above the block surface.
152
Figure 152 — Round Dowel Pin Installation
BLADE-TYPE DOWEL PIN INSTALLATION
1. Position the round end of the blade-type
dowel pin into the dowel pin hole in the
cylinder block. The blade end must be
aligned vertically (up and down) with the
block.
2. Using a hammer, drive the dowel pin into the
block until the shoulder of the pin is flush
with the cylinder block surface.
1. Locating Pin Driver
2. Round Dowel Pin
3. Cylinder Block
4. Dowel Pin Hole
5_106_00.bk Page 160 Friday, August 4, 2000 11:17 AM
BDC for engine manuals and specs
