(
C
ompetition
T
eam
M
otor)
Thank you that you have chosen a product of the "Revenge CTM" series. Here you get a high quality competition
product, developed by racers for racers, to win races.
Please read the instructions carefully. By using this product you agree to the terms of the warranty of Absima
GmbH.
Precautions & Warnings
Read these instructions carefully before using your new motor!
Make sure that the motor temperature does not exceed 80°C, fit the reduction ratio of the engine when it is too hot
.
When
mounting the motor, pay attention tot he correct length of screws and not to over tight them with to excessive torque force.
Assembly
The screws should not protrude more than 5mm in the motor housing as this could damage the motor winding.
Damage caused by excessively long screws will not be covered by the warranty.
Please note that the solder connections are marked A, B and C and connect the motor to the controller as described. During the
soldering process, ensure that the connections are not shorted by solder to each other.
Cleaning & Maintenance
Clean your Revenge Motor regularly in the area of ball bearings with brush and oils tot he ball bearings with suitable ball bearing
oil.
Gear Ratio & Timing
By the gear ratio you can see based on the temperature if the engine is operating effectively, the temperature should never
exceed 80°C. Approach slowly to the right gear ratio to avoid damage of the motor.
On the side of the motor is a scale where you can see the position of the timing. By loosening the rear screws you can twist the
timing shield
.
Attention:
An increase of the timing brings automatically an increase of the temperature. This depends on both, the timing that is on the
motor, as well as the timing, which is simulated with the controller. Please make sure that you be very careful with the
adjustment of the timings etc.
Technical Information
Approved for:
1:8 Scale*
Part no.:
2130040
2130044
2130041
2130042
2130043
Turns:
1750 KV
1900 KV
2100 KV
2300 KV
2500 KV
RPM-V:
1750
1900
2100
2300
2500
Power:
1670W
1850W
2070W
2100W
2650W
Current A:
110A
120A
125A
145A
160A
Efficiency:
88%
88%
88%
88%
86%
Voltage:
4-6S
4-6S
4-6S
4-6S
3-4S
Poles:
4 Pole
4 Pole
4 Pole
4 Pole
4 Pole
Sensor:
Yes
Adjust. timing:
Yes
Ø w/o fins:
42mm
Shaft diameter:
5mm / Module 1
Absima « Reve
»
