Kodak SRP 30, Operator'S Manual

Page: 295 / 310

Operator’s Guide
8. Clean the rollers and gears on the outside with warm water and a soft brush.
Remove any crystal deposits that may stick to the lateral drive gears. Flush the
deposits down the sink.
9. Dismount the guide elements to clean the inside rollers. For this, press together
the bearings clipped into the side parts at the catches and take them out.
On the CD and BX racks, dismount in addition the four styrodur displacers
mounted in holders on both sides.
10. Clean the rollers with a soft brush. Clean the guide elements with warm water
and a lint-free cloth.
11. Let the racks drip dry.
a. Mount the guide elements.
b. Clip the bearings of the guide elements securely into the plates.
c. Mount the displacers and fasten them securely in the holders.
d. Check for and tighten any loose hardware.
12. Check the smooth movement of the racks by turning the drive gear.
13. Insert the cleaned racks slowly into the tanks in the correct order.
14. Reinstall the CD feed unit, crossovers and squeegee unit according to the
instructions on Page 8-23.
15. Close the wet section cover. (For important safety information, see Opening and
Closing the Wet Section Cover on Page 8-20.)
8-42 KODAK PROFESSIONAL SRP 30 Laser Printer