![background image](http://html2.mh-extra.com/html/keithley/interactive-sourcemeter-2450/interactive-sourcemeter-2450_reference-manual_4033478463.webp)
Section 6: SCPI command reference
Model 2450 Interactive SourceMeter® Instrument Reference Manual
6-146
2450-901-01 Rev. B/September 2013
:TRIGger:BLOCk:NOTify
This command defines a trigger model block that generates a trigger event and immediately continues to the next
block.
Type
Affected by
Where saved
Default value
Command only
Recall settings
Instrument reset
Power cycle
Save settings
Not applicable
Usage
:TRIGger:BLOCk:NOTify <blockNumber>, <notifyID>
<blockNumber>
The sequence of the block in the trigger model
<notifyID>
The identification number of the notification; 1 to 8
Details
When the trigger model reaches a notify block, the instrument generates a trigger event and
immediately continues to the next block.
You can define up to eight notify blocks in a trigger model. You can reference the event that the notify
block generates by other commands to assign a stimulus somewhere else in the system. For
example, you can use the notify event as the stimulus of a hardware trigger line, such as a digital I/O
line.
When you call this event, you use the format
NOTIFY
followed by the notify ID. For example, if you
assign
<notifyID>
as
4
, you would refer to it as
NOTIFY4
in the command that references it.
Example
:TRIG:BLOC:NOT 5, 2
:TRIG:BLOC:BRAN:EVEN 6, NOTIFY2, 2
Define trigger model block 5 to be the notify 2
event. Assign the notify 2 event to be the trigger
for stimulus for the branch event for block 6.
Also see
(on page 3-97)