Section 8: TSP command reference
Model 2450 Interactive SourceMeter® Instrument Reference Manual
8-74
2450-901-01 Rev. B/September 2013
Details
Enable this attribute to have the instrument automatically send generated events that are stored in the event log.
The event log is cleared when the event is sent.
Events are processed after a command message is executed but before prompts are issued (if prompts are
enabled with
localnode.prompts
).
If this attribute is disabled, errors are left in the event log and must be explicitly read or cleared.
If you are using this command from a remote node, replace
localnode
with the node reference, such as
node[5].showevents
.
Example
localnode.showevents = 4
Send generated warning and information
messages, but do not send error messages.
Also see
(on page 8-54)
(on page 8-71)
localnode.version
This attribute stores the instrument version.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Attribute (R)
Yes
Not applicable
Not applicable
Not applicable
Usage
version
= localnode.version
version
Instrument version level
Details
This attribute indicates the version number of the firmware that is presently running in the instrument.
When using this command from a remote node,
localnode
should be replaced with the node reference. For
example,
node[5].version
.
Example
print(localnode.version)
Outputs the present version level. Example output:
1.0.0a
Also see
(on page 8-70)
(on page 8-72)
