Section 8: TSP command reference
Model 2450 Interactive SourceMeter® Instrument Reference Manual
8-24
2450-901-01 Rev. B/September 2013
Example
reset()
testData = buffer.make(100)
trigger.model.load("SimpleLoop", 3, 0, testData)
trigger.model.initiate()
waitcomplete()
print(testData.n)
print(defbuffer1.n)
print(defbuffer2.n)
Create a reading buffer named
testData
, configure the instrument to
make three measurements, and store the
readings in the buffer.
Print the number of readings in
testData
:
Output:
3
Print the number of readings in
defbuffer1
:
Example output:
66
Print the number of readings in
defbuffer2
:
Example output:
0
Also see
(on page 8-9)
(on page 8-11)
(on page 8-17)
(on page 8-77)
(on page 8-78)
(on page 3-10)
(on page 3-27)
bufferVar.readings
This attribute contains the readings stored in a specified reading buffer.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Attribute (R)
Yes
Restore configuration
Instrument reset
Power cycle
Not applicable
Not applicable
Usage
readings
=
bufferVar
.readings[
N
]
readings
The readings in the specified reading buffer
bufferVar
The name of the reading buffer, which may be a default buffer (
defbuffer1
or
defbuffer2
) or a user-defined buffer
N
The reading number
N
; can be any value between 1 and the number of readings in
the buffer; use the
bufferVar.
n
command to determine the number of readings
in the buffer
Example 1
reset()
tD = buffer.make(50)
trigger.model.load("SimpleLoop", 3, 0, tD)
trigger.model.initiate()
waitcomplete()
print(tD.readings[1])
Create a reading buffer named
tD
, configure the
instrument to make three measurements, and
store the readings in the buffer.
Print the first reading in
tD
.
Output:
-9.6420389034124e-12