Juniper JUNOSE 11.3, Configuration Manual

Page: 486 / 632

•
Use to set the skip priority rate limiter for the protocol.
•
The specified protocol is not subject to the priority rate limiter for the priority and DoS
protection group selected.
•
The default sets the protocol such that it is subject to priority rate limiting.
•
Example
host1(config-dos-protection)# protocol IpLocalDhcpIc skip-priority-rate-limiter
•
Use the no version to set the value to the default, which is not to use
skip-priority-rate-limiter.
•
See protocol skip-priority-rate-limiter.
protocol weight
•
Use to set the weight for the protocol.
•
For each port compression, weight determines the effective minimum rate that each
protocol receives.
•
Within each port compression, the sum of the minimum rates for all protocols is equal
to or less than the priority rate.
•
For each priority, there is a separate rate for each DoS protection group.
•
Example
host1(config-dos-protection)# protocol IpLocalDhcpIc weight 100
•
Use the no version to set the weight to the value specified in the associated default
group.
•
See protocol weight.
use canned-group
•
Use to create a DoS protection group that uses a pre-programmed set of parameters.
•
Use the revert keyword to return the values to the canned group values
•
Example
host1# use canned-group group1
•
Use the no version to associate the group with the default canned group settings.
•
See use canned-group.
vlan dos-protection-group
•
Use to attach a VLAN DoS protection group to an interface.
•
Example
host1(config-if)# vlan dos-protection-group
•
Use the no version to remove the attachment of the DoS protection group from the
interface.
•
See vlan dos-protection-group.
Copyright © 2010, Juniper Networks, Inc. 456
JunosE 11.3.x System Basics Configuration Guide