Juniper JUNOSE 11.3, Configuration Manual

Page: 302 / 632

host1(config-line)# login
host1(config-line)# timeout login response 15
timeout login response
•
Use to set the time interval that the console or vty lines wait for the user to log in.
•
If the interval passes and the user has not responded, the system closes the session
or lines.
•
Specify an interval in the range 0–300 seconds. A value of 0 means that there is no
time limit during which the user must respond.
•
The default value is 30 seconds.
•
Example
host1(config-line)# timeout login response 15
•
Use the no version to restore the default interval, 30 seconds.
•
See timeout login response.
Setting Time Limits for User Input
You can specify a time interval that the CLI waits for user input on the console or vty lines.
To do so:
1.
Access the line configuration mode using either the console or vty keyword.
2.
Specify the time during which the user must enter information. For example:
host1(config)# line vty 0
host1(config-line)# exec-timeout 4192 13
exec-timeout
•
Use to set the time interval that the console or vty lines wait for expected user input.
•
If the interval passes and the user has not responded, the system closes the session
or lines.
•
Specify a time limit in the range 0–35791 minutes, and optionally specify the number
of seconds.
•
By default, there is no time limit.
•
Example
host1(config-line)# exec-timeout 4192 13
•
Use the no version to remove the time limit.
•
See exec-timeout.
Configuring CLI Messages
You can configure text banners for the CLI to display to users at different times in the
connection process.
Copyright © 2010, Juniper Networks, Inc. 272
JunosE 11.3.x System Basics Configuration Guide