Juniper JUNOSE 11.3, Configuration Manual

Page: 156 / 632

Enter configuration commands, one per line. End with CNTL/Z.
host1(config)#
interface fastEthernet 6/0/0
host1(config-if)# ip address ipAddress [ mask ]
5.
Press Ctrl+z to return to Privileged Exec mode.
Task 5: Configure Access to the Network Host
To configure access to the network host:
1.
Use the ping command to determine whether the router can reach the network host.
host1# ping ipAddress
If the router can reach the network host, go to the next section. Otherwise, go to Step 2.
2.
Determine whether a route exists between the router and the network host.
host1# show ip route
If the appropriate route is displayed, go to Step 4. Otherwise, proceed with Step 3.
3.
Configure a route to reach the network host.
host1# configure
Configuring from terminal or file [terminal]?
Enter configuration commands, one per line. End with CNTL/Z.
host1(config)#
ip route ipNetwork networkMask ipNextHop
4.
Press Ctrl+z to return to Privileged Exec mode.
5.
Determine whether the router has been configured to recognize the network host.
host1# show host
If the network host is listed, go to Step 8. Otherwise, proceed with Step 6.
6.
Add an entry to the Static Host Table so that the router can access the network host.
Use the host command to specify the network hostname and IP address.
host1# configure
Configuring from terminal or file [terminal]?
Enter configuration commands, one per line. End with CNTL/Z.
host1(config)#
host hostName ipAddress ftp loginname password
7.
Press Ctrl+z to return to Privileged Exec mode.
8.
Use the ping command to determine whether the router can now reach the network
host.
host1# ping hostname
If the router cannot reach the network host, verify that you correctly performed the
previous steps in this procedure and that the network host is operational.
Task 6: Copy the Release Files to the Network Host
If you downloaded the software from the Juniper Networks website as a .zip file,
uncompress the files to a directory, and copy the release files to the network host.
If you are accessing the release files from one of the software CDs that you created from
the downloaded software image package, you must mount the CD. The way you mount
Copyright © 2010, Juniper Networks, Inc. 126
JunosE 11.3.x System Basics Configuration Guide