Juniper JUNOSE 11.3, Configuration Manual

Page: 473 / 632

•
Suspicious—Protocol detected as receiving an excess amount of traffic within
the last backoff time in number of seconds.
•
Transitions—Number of times this protocol or priority has transitioned to the
suspicious state
•
Example
host1(config)# show suspicious-control-flow-detection info slot 2
Suspicious Flow Detection System Information
Suspicious Flow Detection System is enabled
Using Groups
The suspicious control flow system is not in overflow state or using groups
Protocol Information
Protocol State Transitions
--------------------------------------- ---------- -----------
Ppp Echo Request OK 0
Ppp Echo Reply OK 0
Ppp Echo Reply Fastpath OK 0
Ppp Control OK 0
Atm Control (ILMI) OK 0
Atm OAM OK 0
Atm Dynamic Interface Column Creation OK 0
Atm Inverse ARP OK 0
Frame Relay LMI Control OK 0
Frame Relay Inverse Arp OK 0
Pppoe Control OK 0
Pppoe Config Dynamic Interface Column OK 0
Creation
Ethernet ARP Miss OK 0
Ethernet ARP OK 0
Ethernet LACP packet OK 0
Ethernet Dynamic Interface Column OK 0
Creation
Slep SLARP OK 0
MPLS TTL Exceeded On Receive OK 0
MPLS TTL Exceeded On Transmit OK 0
MPLS MTU Exceeded OK 0
Ipsec Transport Mode L2tp Control OK 0
NAT/Firewall Payload OK 0
NAT/Firewall Update Table OK 0
DHCP External OK 0
IP OSI OK 0
IP TTL Expired OK 0
IP Options Other OK 0
IP Options Router Alert OK 0
IP Multicast/Broadcast Other OK 0
IP Multicast DHCP (SC) OK 0
IP Multicast Control (SC) OK 0
IP Multicast Control (IC) OK 0
IP Multicast VRRP OK 0
IP Mulitcast Cache Miss OK 0
IP Multicast Cache Miss Auto Reply OK 0
IP Multicast Wrong Interface OK 0
IP Local DHCP (SC) OK 0
IP Local Dhcp (IC) OK 0
IP Local Icmp Echo OK 0
IP Local Icmp Other OK 0
443 Copyright © 2010, Juniper Networks, Inc.
Chapter 7: Passwords and Security