Juniper JUNOSE 11.3, Configuration Manual

Page: 192 / 632

•
Use the no version to remove the specified host from the list of recipients.
•
See snmp-server host.
snmp-server trap-source
•
Use to specify the interface whose IP address is used as the source address for all
SNMP traps.
NOTE: When there are multiple IP addresses configured on the IP interface
that is chosen as the SNMP trap source, the SNMP agent automatically
uses the primary IP address of the interface as the SNMP source address
on SNMP traps.
•
Example
host1(config)# snmp-server trap-source fastethernet 0/0
•
Use the no version to remove the interface from the trap configuration.
•
See snmp-server trap-source.
snmp trap ip link-status
•
Use to enable link-status traps on an IP interface.
•
Example
host1(config-if)# snmp trap ip link-status
•
Use the no version to disable link-status traps on an IP interface.
•
See snmp trap ip link-status.
snmp trap ip link-status
•
Use to configure the SNMP link-status traps on a particular interface.
•
A link-up trap recognizes that a previously inactive link in the network has come up.
•
A link-down trap recognizes a failure in one of the communication links represented
in the server’s configuration.
•
Example
host1(config-controll)# snmp trap link-status
•
Use the no version to disable these traps for the interface.
NOTE: This command operates in Controller Configuration mode. It is
supported only by the DS3, DS1, and FT1 interface layers.
•
See snmp trap ip link-status.
traps
Copyright © 2010, Juniper Networks, Inc. 162
JunosE 11.3.x System Basics Configuration Guide