Juniper JUNOSE 11.3, Configuration Manual

Page: 141 / 632

host1(config)#
snmp-server management-event
host1(config-mgmtevent)# ?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
event Specify what happens when an event is triggered
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
resource Specify the resource limits
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
trigger Specify the conditions that lead to events
Statistics Profile Configuration Mode
In this mode, you can configure a statistics profile. You can then set the rate period during
which statistics are gathered, enable statistics gathering, and enable the counting of
drop and forwarding events.
From Global Configuration mode, type statistics-profile and the statisticsProfileName
that you want to create or configure, and press Enter.
host1(config)#
statistics-profile statpro-1
host1(config-statistics-profile)# ?
committed-drop-threshold Set threshold for logging a committed-drop event
conformed-drop-threshold Set threshold for logging a conformed-drop event
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exceeded-drop-threshold Set threshold for logging an exceeded-drop event
exit Exit from the current command mode
forwarding-rate-threshold Set threshold for logging a forwarding-rate event
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
rate-period Set the time period for calculating queue rates
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified
duration
Subinterface Configuration Mode
In this mode, you can configure one or more virtual interfaces, called subinterfaces , on a
single physical interface. The system supports this feature with ATM and Frame Relay.
Both ATM and Frame Relay provide permanent virtual circuits (PVCs) that can be grouped
under separate subinterfaces configured on a single physical interface. Subinterfaces
allow multiple encapsulations for a protocol on a single interface.
From Interface Configuration mode, indicate a subinterface by typing the interface
command and an interfaceSpecifier in s lot/port.subinterface format, and then press Enter.
For example:
host1(config-if)# interface atm 3/2.6
host1(config-subif)#
111 Copyright © 2010, Juniper Networks, Inc.
Chapter 2: Command-Line Interface