Juniper JUNOSE 11.3, Configuration Manual

Page: 155 / 632

•
The login name and password for the FTP server
• The procedure for copying the release files to the network host
Task 2: Divert Network Traffic to Another Router
The system will be unavailable during the installation process.
Task 3: Access Privileged Exec Mode
To access this mode via the CLI:
1.
Issue the enable command.
host1> enable
2.
Type the password if the system prompts you.
Task 4: Configure IP on an Interface
Typically, you configure IP on the Fast Ethernet interface of the SRP module. To configure
IP on an interface:
1.
Determine the slot number of the module.
host1# show version
2.
Determine the port number of the module.
3.
Determine whether the interface already has an IP address.
• On ERX7xx models, ERX14xx models, and the ERX310 router:
host1# show ip interface fastEthernet 6/0
•
On the E120 and E320 routers:
host1# show ip interface fastEthernet 6/0/0
NOTE: If an IP interface is not configured, an Invalid interface message
appears.
If the interface already has an IP address, go to Step 5. Otherwise, proceed with Step
4.
4.
Configure an IP address on the interface.
•
On ERX7xx models, ERX14xx models, and the ERX310 router:
host1# configure
Configuring from terminal or file [terminal]?
Enter configuration commands, one per line. End with CNTL/Z.
host1(config)#
interface fastEthernet 6/0
host1(config-if)# ip address ipAddress [ mask ]
• On the E120 and E320 routers:
host1# configure
Configuring from terminal or file [terminal]?
125 Copyright © 2010, Juniper Networks, Inc.
Chapter 3: Installing JunosE Software