Juniper JUNOSE 11.3, Configuration Manual

Page: 344 / 632

Specifying the Core Dump Monitor Interval
To specify the length of time that the router waits between checking for core dump files,
use the
exception monitor interval command. Use the no version of this command to
revert the core dump monitor interval to its default value of 60 minutes (1 hour).
exception monitor interval
•
Use to specify the interval (in minutes) at which you want the router to check NVS for
core dump files.
•
Example
host1(config)# exception monitor interval 1000
•
Use the no version to revert the core dump monitor interval to its default value, 60
minutes.
•
See exception monitor interval.
Viewing Core Dump Monitor Status
To view information about core dump monitor status and configuration, use the show
exception monitor command.
show exception monitor
•
Use to display information about the core dump monitor status and configuration.
•
Field descriptions
•
Core dump monitor—Status (enabled or disabled) of the core dump monitor
•
Next dump monitor check time—Time at which the core dump monitor will next
check for any new core dump files
•
Host—IP address of the FTP host on which the core dump monitor saves core dump
files
•
Directory—Directory or directory path on the host to where the core dump files are
located
•
Core dump monitor interval—Time interval (in minutes) at which the core dump
monitor checks for any new core dump files
•
Files on flash which have been transferred—A list of core dump files in the router
NVS that have already been transferred to the FTP host
•
Files on flash which have not been transferred—A list of core dump files in the router
NVS that have not yet been transferred to the FTP host
•
Example
host1# show exception monitor
Core dump monitor is enabled
Next dump monitor check time: WED AUG 16 2003 15:50:38 UTC
Host: 10.10.120.99
Copyright © 2010, Juniper Networks, Inc. 314
JunosE 11.3.x System Basics Configuration Guide