Juniper JUNOSE 11.3, Configuration Manual

Page: 354 / 632

•
slots: cards missing or offline—Status of each slot
•
online
•
standby
•
offline
•
empty
•
line redundancy—Number of redundancy groups installed
•
width—Number of slots the redundant midplane covers
•
spare—Slot that contains a spare line module
•
primary—Slot that contains the primary line module
•
fabric redundancy—Status of redundancy on the switch fabric on the E120 and E320
routers
•
ok
•
none
•
temperature—Status of the system temperature
•
timing—Source of the timing signal
•
primary—Type and status of the primary timing signal
•
secondary—Type and status of the secondary timing signal
•
tertiary—Type and status of the tertiary timing signal
•
auto-upgrade—Status of the auto-upgrade parameter, which enables the system
to revert to a higher-priority timing source after switching to a lower-priority timing
source.
•
system operational—Status of the system
•
slot—Number of the slot in which the module resides
•
type—Type of module in the slot on the E120 and E320 routers
•
temperature—Temperature of the line module, SRP module, or SFM on the E120
and E320 routers
•
processor temperature—Temperature of the line module or SRP module
•
processor temperature status—Temperature condition of the line module
•
normal—Temperature is in normal range
•
too hot—Module is too hot; system will go into thermal protection mode if the
temperature of any module exceeds 80° C
Copyright © 2010, Juniper Networks, Inc. 324
JunosE 11.3.x System Basics Configuration Guide