Juniper JUNOSE 11.3, Configuration Manual

Page: 290 / 632

•
Use the no version to restore the default action, manual detection.
•
See service check-config.
service config-monitor-periodicity
•
Use to set the time for background monitoring of the active and standby SRP. By
default, background monitoring is not running. For corruption detection of the CNF
files, you must use manual mode.
•
Auto mode checks the running configuration at regular intervals; auto mode cannot
be used for CNF files.
•
Use the default version to restore the default setting, manual detection.
•
Example
host1(config)# service config-monitor-periodicity 2000
•
There is no no version.
•
See service config-monitor-periodicity.
show service config-monitor-periodicity
Use to display the time of the monitoring task for detecting corruption of a running
configuration on both the primary SRP and the standby SRP.
•
•
Example
host1# show service config-monitor-periodicity
config-monitor-periodicity = 2000
•
See show service config-monitor-periodicity.
Automatically Recovering Corrupt Configuration Files
You can automatically recover corrupted CFG files detected in the running configuration.
When you turn on auto-recovery, the behavior of the file synchronization, stateful SRP
switchover (high availability), and unified ISSU tasks changes to prevent synchronization
of corrupt configuration. On detecting configuration file corruption, JunosE Software
determines whether a corrupt file is recoverable by the application. If the file is recoverable:
1.
The configuration monitor on the SRP tries to recover it from a good configuration as
determined by the application.
2.
The file synchronization, high availability, and unified ISSU operations are re-enabled.
You can manually or automatically recover the recoverable corrupt configuration files in
the running configuration as determined by the application.
You can use the service check-config auto-recover command to enable auto-recovery
of corrupt CFG files in the running configuration.
You can use the service check-config running-configuration command to view a list of
corrupt files in the running configuration and the files that are recoverable.
Copyright © 2010, Juniper Networks, Inc. 260
JunosE 11.3.x System Basics Configuration Guide