Juniper JUNOSE 11.3, Configuration Manual

Page: 204 / 632

host1(config-mgmtevent-trigger)# boolean-test comparison less
•
Example 2—Specifying a Boolean value to which the test compares
host1(config-mgmtevent-trigger)# boolean-test value 5175438
•
Example 3—Binding an event to the Boolean-test trigger
host1(config-mgmtevent-trigger)# boolean-test event sysadmin booleanTrigger
•
Example 4—Setting the trigger to not perform a Boolean test on startup
host1(config-mgmtevent-trigger)# boolean-test startup
•
Use the no version to delete the Boolean-test values for this trigger or to remove either
the startup condition or event binding.
•
See boolean-test.
delta-sampling
•
Use to specify delta sampling for the trigger you are configuring.
•
Example
host1(config-mgmtevent-trigger)# delta-sampling
•
(Optional) Use the discontinuity-id option to specify a discontinuity MIB ID for the
sample. The discontinuity MIB ID monitors the sample for any discontinuity errors during
the sample frequency. If a discontinuity error occurs, the router removes the sampling
for that interval.
•
(Optional) Use the discontinuity-id-type option to specify a discontinuity ID type
(either timeStamp or timeTicks). The discontinuity ID type indicates the time value
that you expect for a specific sample.
•
Use the no version to turn off delta sampling and use absolute sampling (the default).
•
See delta-sampling.
enable
•
Use to enable an event configuration or trigger configuration.
•
Example 1—Event Configuration Mode
host1(config-mgmtevent-event)# enable
•
Example 2—Trigger Configuration Mode
host1(config-mgmtevent-trigger)# enable
•
Once enabled, you cannot edit an event or trigger configuration (even when it is
disabled). To change an enabled event or trigger, you must delete it and re-create it.
•
There is no no version.
•
See enable.
event
Copyright © 2010, Juniper Networks, Inc. 174
JunosE 11.3.x System Basics Configuration Guide