Juniper JUNOSE 11.3, Configuration Manual

Page: 200 / 632

host1(config-mgmtevent)#
NOTE: Once enabled, you cannot edit an event or trigger configuration.
To change an enabled event or trigger, you must delete it and re-create
it.
6.
Define the trigger that you want to use for an event by specifying a trigger owner and
trigger name.
host1(config-mgmtevent)# trigger george trigger1
host1(config-mgmtevent-trigger)#
7.
Specify a MIB object to sample.
host1(config-mgmtevent-trigger)# sample value-id 1.3.6.1.2.1.60.1.2.1.1.7
8.
Specify the frequency (in seconds) at which you want the sampling to occur.
host1(config-mgmtevent-trigger)# frequency 100
NOTE: Unless you specify that you want to perform delta sampling, the
values are absolute.
9.
(Optional) Specify that you want to perform delta sampling on the sample value ID.
host1(config-mgmtevent-trigger)# delta-sampling
•
(Optional) Enter the discontinuity MIB value ID that you want to test.
host1(config-mgmtevent-trigger)# delta-sampling discontinuity-id
1.3.6.1.2.1.31.1.1.1.19.9
• (Optional) Enter the discontinuity type (timeStamp or timeTicks) that you want
the test to use.
host1(config-mgmtevent-trigger)# delta-sampling discontinuity-id-type timeStamp
10.
(Optional) Configure the desired SNMP security level for the agent that you want to
poll.
host1(config)# snmp security read
11.
Define the test values that you want this trigger to use.
You can define a Boolean test, existence test, or threshold test. See the following
sections for procedures.
Defining a Boolean Test
You can configure a Boolean trigger to test whether the value of an integer object is equal,
unequal, greater than, less than, less than or equal to, or greater than or equal to some
defined value.
To define a Boolean test:
1.
Define the Boolean-test comparison that you want this trigger to use.
Copyright © 2010, Juniper Networks, Inc. 170
JunosE 11.3.x System Basics Configuration Guide