HP MSR SERIES, Configuration Manual

Page: 734 / 889

717
Item Description
DTMF Detection Sensitivity
Level
Set the DTMF detection sensitivity level.
•
Low —In this mode, the reliability is high, but DTMF tones might fail to be
detected.
•
High —In this mode, the reliability is low and detection errors might occur.
Status
•
Enable.
•
Disable.
Configuring a paging line
Select
Voice Management
>
Line Management
from the navigation tree, and then click the icon of
the paging line to be configured to access the audio interface configuration page, as shown in Figure
734 .
Figure 734 Configuring SIC-audio page interface
Table 276 Configuration items
Item Description
Line Description Specify the description of the paging line.
Voice Interface Output
Gain
When a relatively small voice signal power is needed on the output line, increase the
voice output gain value.
IMPORTANT:
Gain adjustment might lead to call failures. HP recommends not adjusting the gain. If
necessary, do it with the guidance of technical personnel.
Silent Mode
•
Enable.
•
Disable.
By default, the silent mode is disabled.
IMPORTANT:
If the silent mode is enabled on an audio interface, the interface cannot transmit data.
Voice Output Gain
Set the value of the audio input gain, in the range of –24.0 to +12.0 with a step of
1. When a relatively small voice signal power is needed on the output line, increase
the voice output gain value.
IMPORTANT:
Gain adjustment might lead to call failures. HP recommends not adjusting the gain. If
necessary, do it with the guidance of technical personnel.