Honda TRX400EX FOURTRAX 1999, Service Manual

Page: 198 / 263

REAR
Press the
marking side
the bearing.
the slider
wear
groove fac-
ing aligning
its with the
Apply grease to new needle bearing rollers.
Carefully press the needle bearing and thrust bush-
ing into the swingarm pivot until the bushing is fully
seated.
TOOL
Needle bearing remover
07946
-
Pack grease into new inner dust seal lip cavities.
Install the inner dust seals until they are flush with
the pivot surfaces.
Install the pivot collars.
INSTALLATION
Install the following if they are removed:
- under cover with the bolt
- chain slider with the bolts and collars
Pack grease into new outer dust seal lip cavities.
Install the outer dust seals onto the swingarm pivots
and the seal caps over the dust seal securely.
Set the swingarm into the frame, take care to prevent
removing the dust seal caps, and install the pivot bolt
from the right side.
Install the pivot nut and tighten it.
TORQUE:
108 (11.0 80
Connect the shock link to the swingarm and the
shock absorber to the shock arm by inserting the
pivot bolts from the right side.
Install the nuts and tighten them.
TORQUE:
Shock link-to-swingarm:
Shock absorber mounting:
44 (4.5 33
59 (6.0 43
NEEDLE BEARING
-
--
AND N JT
BOLTS AND NUTS
LINK'
ABSORBER
13-14