Honda TRX400EX FOURTRAX 1999, Service Manual

Page: 193 / 263

REAR
Thelocknuts
threads.
Turn the outer lock nut clockwise until the stopper
ring groove is covered with the outer lock nut and
apply locking agent to the lock bolt threads as shown.
Turn the outer lock nut counterclockwise until the
ring groove i s visible and install the stopper ring into
the groove.
Apply grease to the stopper ring (outer lock nut seat-
ing surface) and turn the outer lock nut to seat it
against the stopper ring.
Tighten the outer lock nut.
TOOL
Lock nut wrench, 45 m m
07916
-
1870101 or
equivalent commercially
available
in
Refer to torque
wrench reading
on
page
"SERVICE lock bolt threads.
INFORMATION".
TORQUE: Actual: 88 (9.0 65
Indicated: 79 (8.1 59
Apply locking agent to the inner lock nut area of the
Tighten the inner lock nut while holding the outer
lock nut.
TOOLS
Lock nut wrench, 56 m m 07916
-
HA20000
or
07916
-
(U.S.A.
07916
-
1870101 or
equivalent commercially
available in
TORQUE: Actual: 128 (13.0 94
Lock nut wrench, 45 mm
Indicated: 115
(11.7
Tighten the driven sprocket nuts if the sprocket was
removed.
TORQUE 59 (6.0 43
Install the brake caliper (page
Install the skid plate (page
Adjust the drive chain slack (page 3-13)
REAR SHOCK ABSORBER
REMOVAL
UTER LOCK NUT
WRENCH
Remove the fender (page
Support the vehicle with a support block to raise the
rear wheels off the ground.
Support the and remove the mounting
nuts, bolts and the shock absorber.
INSPECTION
Becarefulnot to
lose
needle
bearing.
Remove the upper pivot collar and check the needle
bearing, pivot collar and dust seals for wear or
damper unit for leakage or other damage.
Replace the shock absorber assembly if necessary.
rollers o f the
age.