Gigamon GigaVUE-HC3, Hardware Installation Manual

Page: 99 / 142

Basic GigaVUE H Series Connections and Configuration 99
ping Sends ICMP echo requests to a specified host.
ping6 Sends IPMPv6 echo requests to a specified IPv6 host.
pld Upgrades programmable logic devices (PLDs) on GigaVUE-HC3 nodes.
policy Configures an active visibility policy.
port Configures port type, parameters, and filters.
port-group Creates a group of ports.
port-pair Configures a port-pair on a pair of network ports within the same GigaVUE H Series node. A
port-pair is a bidirectional connection in which traffic arriving on one port in the pair is transmitted out
the other (and vice-versa) as a pass-through TAP.
ptp Enables and disables the use of PTP.
radius-server Configures RADIUS server settings for authentication.
redundancy-profile Configures an inline redundancy profile on GigaVUE HC Series nodes.
reload (reboot) Reboots or shuts down the node.
reset Resets specified portions of the node configuration to their factory states.
serial Sets options for the serial console port.
sfp Reserved for future use.
show Displays configuration and status information for GigaVUE H Series settings and entities.
sleep Sleeps for a specified number of seconds.
snmp-server Configures SNMP settings, including the local SNMP server, notification events, and notification
destinations.
spine-link Configures spine links in a cluster with a leaf and spine architecture.
ssh Enables and disables SSH access, as well as manages settings.
stack-link Configures a stack-link between two GigaVUE H Series nodes in a cluster. Stack-links are used to
carry data traffic between nodes in a GigaVUE H Series cluster.
sync Enables dynamic control card synchronization for a GigaVUE-HD8 node.
system Changes system settings.
system-health Configures system health behaviors.
tacacs-server Configures server settings for authentication.
telnet-server Enables or disables Telnet access.
terminal Sets terminal parameters, including width and length.
timestamp Configures the timestamp source.
tool-mirror Configures a tool-mirror connection between two tool ports. A tool-mirror connection sends all
packets arriving on one tool port to a second tool port on the same node.
traceroute Traces the route packets take to a destination.
tunnel Reserved for future use.
Table 4-2: CLI Commands
Command Description