Gigamon GigaVUE-HC3, Hardware Installation Manual

Page: 35 / 142

Introducing the GigaVUE-HC3 35
Inline Network Ports
Connect inline networks to the inline network ports. The inline network ports have
built-in protection for power down.
The inline network ports have the following labels:
• A1—Inline network port A (for network 1)
• B1—Inline network port B (for network 1)
• M1—Inline network mode (for network 1)
• A2—Inline network port A (for network 2)
• B2—Inline network port B (for network 2)
• M2—Inline network mode (for network 2)
The inline network port status LEDs (A1, B1, A2, B2) have the following states:
• OFF indicates that the port link is down
• GREEN indicates that the link is established
The physical bypass mode LEDs (M1, M2) have the following states:
• GREEN indicates inline
• OFF indicates bypass
Maximum BPS-HC3-C25F2G
Modules Per Chassis
The maximum number of BPS-HC3-C25F2G modules per chassis is four. Each module can
support up to two 100Gb/40Gb inline network port pairs, for a total of eight, and sixteen
10Gb ports for a total of sixty-four.
Network, Tool, Hybrid or
Stack Ports
The sixteen 10Gb ports on the BPS-HC3-C25F2G module can be used as a network, tool,
hybrid, or stack ports.
10Gb Inline Ports
The sixteen 10Gb ports can be configured as inline network or inline tool ports, supporting
logical bypass on 10Gb ports.
10Gb and 25Gb Ports
Every group of four ports (quad) can be configured as 25Gb. In one quad, there cannot be a
mix of 10Gb and 25Gb ports. By default, all sixteen ports are configured as 10Gb ports. To
configure 25Gb, you must configure the port speed as follows:
(config) # port x1..x4 params admin enable
(config) # port x1..x4 params speed 25000
100Gb/40Gb Inline Network
Ports
By default, the inline network ports are 100Gb, but can be configured as either 100Gb or
40Gb, supporting physical bypass at 100Gb or 40Gb port speeds. Each port pair (c1 and c2
or c3 and c4) must be configured with the same port speed. For changing the port speed,
refer to the
port <port> params speed command in the GigaVUE-OS CLI User’s Guide .
Inline Network Ports c1..c4
or
c1x1..c1x4,
c2x1..c2x4,
c3x1..c3x4,
c4x1..c4x4
The BPS-HC3-C25F2G module includes four 100Gb ports (c1..c4). These ports also support
40Gb speeds.
The 40Gb/100Gb ports on the BPS-HC3-C25F2G module can be broken out into 4 times
10Gb ports or 25Gb ports, called subports. The subports will all have the same speed (10Gb
or 25Gb). Subports will have x1 to x4 appended to their port ID, for example, 1/1/c2x1.
For more information, refer to Port Modes for BPS-HC3-C25F2G on page 37 .
Once a port has been broken out into subports, cable it to an optical patch panel or breakout
panel, such as PNL-M341, which takes input from the BPS-HC3-C25F2G module and splits
it to four independent output ports. Refer to
Breakout Panels on page 44 .