Gigamon GigaVUE-HC3, Hardware Installation Manual

Page: 137 / 142

D NEBS Level 3 Compliance 137
b.
All bare grounding connection points to the GigaVUE-HC3 shall be cleaned and
coated with an antioxidant solution before connections are made.
c.
All surfaces on the GigaVUE-HC3 that are unplated shall be brought to a bright
finish and treated with an antioxidant solution before connections are made.
d.
All non-conductive surfaces on the GigaVUE-HC3 shall be removed from all
threads and connection points to ensure electrical continuity.
e.
Multiple connectors shall not be secured by the same bolt assemblies.
f.
Unplated connection surfaces that are to be intentionally joined to form a
bonding or grounding path shall be brought to a bright finish and then coated
with an antioxidant before they are joined (electrical connections).
g.
Listing fasting hardware shall be compatible with materials being joined and
shall preclude loosening deterioration, and electrochemical corrosion of the
hardware and joined materials.
h.
Non-conductive coatings (such as paint, lacquer, and enamel) on the
equipment to be bonded or grounded shall be removed from threads and other
contact surfaces to assure electrical continuity.
i.
GigaVUE-HC3 utilizes a Spade width 0.32in/.81cm with a Standard Wire 12-16
(AWG) that utilizes 5in-lbs of torque to secure it to the frame and EUT. Only
listed two-hole compression-type connectors shall be used in making
connection to flat surfaces (such as bus bars, frames, racks, or cabinets).
Torquing and bolts assembly requirements for securing the connector shall be
as specified by the connector supplier.
Input AC/DC Voltage
The GigaVUE-HC3 is capable of operating input 100-240V AC, 120A, 47-63Hz
and/or -40 to -72V DC, 133A, typically -48V DC.
Maintenance
CAUTION : Remove all power sources before servicing. (TO COMPLETELY REMOVE
POWER FROM THE UNIT, FIRST TURN OFF THE POWER SWITCH AND REMOVE
BOTH POWER CABLES).