Gigamon GigaVUE-HC3, Hardware Installation Manual

Page: 15 / 142

Introducing the GigaVUE-HC3 15
Table 1-2: Extension Board Ports and LEDs
LED LED Color Description
USB Port — Upgrade software on the GigaVUE-HC3 using a software image
on an external USB drive.
CON Port — Configure the GigaVUE-HC3 locally over a serial terminal
connection (RJ-45 console port).
MGMT Port — Configure the GigaVUE-HC3 remotely over a Telnet or SSH
connection (RJ-45 management port, 10/100/1000BASE-T).
PTP Port — In GigaVUE-HC3 Control Card Version 1 (CCv1), the PTP port is
used a eth1. In GigaVUE-HC3 Control Card Version 2 (CCv2),
the PTP port is reserved for future use.
STACK
Ports (3) — Use to connect to other nodes for cluster management.
N
OTE
:
The cluster management stack port link will be displayed
as “up” in the output of the
show interfaces
command, even after
the cable was disconnected. View the link on/off LED on the front
panel of the node to check the state of the cluster management
stack port link.
P/S — Reserved for future use.
PPS(IN) — Reserved for future use.
MGMT Port
LEDs Solid Amber Link up
Blinking Green Activity
STACK
Port LEDs Solid Green Link up/activity
Solid Amber Disabled port
OFF Port is administratively enabled, but the link is down