Gigamon GigaVUE-HC3, Hardware Installation Manual

Page: 129 / 142

B Replacing Control Card 129
(config) # no map all
(config) # no gsop all
(config) # no vport all
(config) # no tunnel all
(config) # no gsgroup all
(config) # no stack alias <alias>
3.
On the GigaVUE-HC3 node, issue the following commands:
(config) # no cluster enable
(config) # write memory
4.
On the cluster master node, remove the GigaVUE-HC3 node information from the
cluster database. Answer YES when prompted. This removes the GigaVUE-HC3
from the cluster.
(config) # no chassis box-id <box ID>
WARNING !! All the cards, ports, and traffic configuration will be lost.
Enter 'YES' to confirm this operation: YES
5.
Replace the control card by following the procedure for Standalone Node on
page 127 up to and including Step 11 . (Since the GigaVUE-HC3 has been
removed from the cluster, it is a standalone node.)
6.
When the GigaVUE-HC3 is back up, reinstate the cluster configuration including
the cluster ID, cluster name, cluster master address vip, cluster master preference,
and cluster interface, as well as the chassis box ID.
(config) # cluster id <cluster ID>
(config) # cluster name <cluster name>
(config) # cluster master address vip <cluster master vip>
(config) # cluster interface eth<x>
(config) # cluster master preference <preference number for master, standby, or normal>
7.
On the cluster master node, configure chassis information on the GigaVUE-HC3,
including the chassis box ID, serial number, and new node type.
(config) # chassis box-id <box ID> serial-num <serial number> type hc3
8.
On the GigaVUE-HC3 node, issue the following command for the node to rejoin the
cluster:
(config) # cluster enable
9.
When the GigaVUE-HC3 node is in the cluster, from the cluster master node apply
the previously saved configuration:
(config) # configuration text fetch <http | https | ftp | tftp | scp | sftp>://<download URL>/<profilename.txt>
apply fail-continue verbose
10.
Verify that the information on the cluster matches the previously saved
configuration for chassis, cards, and traffic using the following CLI commands or
others, depending on your configuration:
(config) # show version
(config) # show cluster global
(config) # show chassis
(config) # show cards
(config) # show map
(config) # show map stats all