Gigamon GigaVUE-HC3, Hardware Installation Manual

Page: 42 / 142

42 GigaVUE-HC3 Hardware Installation Guide
For example, if the box ID is 1, and the BPS-HC3-C35C2G and BPS-HC3-Q35C2G
modules are in slot 3,
Table 1-5 on page 36 lists the default inline networks:
N
OTE
:
Default inline networks cannot be deleted.
BPS Forwarding LED
BPS forwarding LED for each BPS-HC3-Q35C2G and BPS-HC3-C35C2G inline
network port has two LEDs, an upper and a lower, that represent the inline network
forwarding state. For more information, refer to
BPS Forwarding LED on page 36 .
Gigamon Resiliency for Inline Protection
Gigamon Resiliency for Inline Protection (GRIP)™ is an inline bypass solution that
connects two GigaVUE-HC3 nodes together so that one node provides high availability
to the other node when there is a loss of power. This redundant arrangement of two
GigaVUE-HC3 nodes maintains traffic monitoring by inline tools when one of the nodes
is down.
GRIP™ makes use of the bypass protection switch relays for protected inline networks
on GigaVUE-HC3 nodes. The bypass combo module can provide physical protection
for protected pairs of optical inline network ports required by the GRIP solution.
To configure the GRIP solution on BPS-HC3-C25F2G module, the GigaVUE-HC3 must
be running GigaVUE-OS version 5.2.00 or higher. To configure the GRIP solution on
BPS-HC3-Q35C2G and BPS-HC3-C35C2G modules, the GigaVUE-HC3 must be
running GigaVUE-OS version 5.5.00 or higher. For solution and configuration
information, refer to the chapter “Configuring Inline Bypass Solutions” in the
GigaVUE-OS CLI User’s Guide .
N
OTE
:
GRIP is supported on GigaVUE-HC3 only when there are other modules
installed in the node that can provide the stack link. The GRIP solution synchronizes
the nodes through a signaling link using a stack link between two stack ports.
Table 1-9: Default Inline Networks
Default Inline Network Network A
Connected To Network B
Connected To
default_inline_net_1_3_1 1/3/c1 1/3/c2
default_inline_net_1_3_2 1/3/c3 1/3/c4
default_inline_net_1_3_1 1/3/q1 1/3/q2
default_inline_net_1_3_2 1/3/q3 1/3/q4