Gigamon GigaVUE-HC3, Hardware Installation Manual

Page: 83 / 142

Basic GigaVUE H Series Connections and Configuration 83
Removing the Control Card
The GigaVUE-HC3 control card is located in the rear of the chassis behind the fan tray.
It is field replaceable. Since there is only one control card and it is internal, the node
must be powered down. Hot swapping is not possible.
To remove the control card:
1.
If the node is powered on, log in to the serial console port on the node and power it
down gracefully with the
reload halt command.
2.
Power down the node by unplugging the power cable.
3.
Remove the fan tray as described in Removing a Fan Tray on page 79 . The control
card is located behind the fan tray as shown in Figure 4-17 on page 83 .
Figure 4-17: Control Card Location
4.
Swing both ejector handles outward as shown in Figure 4-18 on page 83 .
Figure 4-18: Control Card Ejector Handles