Gigamon GigaVUE-HC3, Hardware Installation Manual, Page: 64 / 142

64 GigaVUE-HC3 Hardware Installation Guide
Module Installation Procedure
Install at least one module in the GigaVUE-HC3 node.
To install GigaVUE-HC3 modules:
1.
Make sure you are wearing an ESD-preventive wrist or ankle strap.
2.
Locate the modules and remove them from their packaging.
3.
Locate the protective filler panels in the bays. Refer to Figure 3-8 on page 64 .
Figure 3-8: Filler Panels Inserted
4.
Use a Phillips screwdriver to loosen the screws on the ejector levers, then loosen
the thumb screws.
5.
Open the levers on a filler panel as shown in Figure 3-9 on page 64 .
Figure 3-9: Filler Panel Levers
Filler panels:
inserted
Thumb screw