Gigamon GigaVUE-HC3, Hardware Installation Manual

Page: 79 / 142

Basic GigaVUE H Series Connections and Configuration 79
2.
Tighten the thumb screws on the fan module, then use a Phillips screwdriver to
tighten the screws.
Removing a Fan Tray
You can remove the entire fan tray using the following procedure.
N
OTE
:
If the node is powered, work quickly to remove the fan tray and insert another
one. The GigaVUE-HC3 should not be without cooling for more than 60 seconds.
To remove the entire fan tray:
1.
Locate the two thumb screws at the bottom of the fan tray as shown in Figure 4-10
on page 79 .
Figure 4-10: Fan Tray Screw Location on GigaVUE-HC3 Rear
2.
Use a Phillips screwdriver to loosen the screws on the fan tray, then loosen the
thumb screws.
3.
Pull the failed fan tray out of the slot and set it aside. Refer to Figure 4-11 on
page 79 .
Figure 4-11: Fan Tray Removal