118
GigaVUE-HC3 Hardware Installation Guide
The GigaVUE-HC3 node provides three command entry modes, each with
increasingly powerful rights –
Standard
,
Enable
, and
Configure
. Module and port
configuration commands are only available in Configure mode:
a.
Type
en <Enter>
to switch to Enable mode.
The system prompt changes from
[hostname]
>
to
[hostname]
#
.
b.
Type
config t <Enter>
to switch to Configure mode.
The system prompt changes from
[hostname]
#
to
[hostname]
(config) #
.
3.
Use the following command to check module status:
(config) # show cards
4.
Check the values in the
Config Status
and
Oper
Status
columns for all modules
and verify that they read
Yes
for configured and
Up
for inserted. This is your
indication that the node is ready for further configuration.
5.
If the
Config Status
does not show
Configured
for all modules after two minutes,
take the action corresponding to your
show cards
output, as follows:
The
card
command initializes unconfigured module. However, it can only be used
after the node’s box ID has been configured, as reported at the top of the
show
cards
output in
.
6.
Use the
show cards
command again to verify the following:
•
Box ID
is not empty.
•
Config Status
shows
configured
for all modules.
•
Oper Status
shows
up
for all modules.
highlights the
show cards
output for a node with properly
configured modules.
Figure 5-3: Successful show cards Output
show cards Output:
Corrective Action
Config Status
does not show
Configured
for any cards
(including control cards)
(config) # chassis box-id <integer>
(config) # card all
Config Status
shows
Configured
for control cards
but not one or more modules
(config) # card slot
x
N
OTE
:
If all modules are unconfigured, you can also use the
card all
command. If some cards are already configured,
however (for example, because you just installed a new card), it
is better to use
slot
x
for the unconfigured cards.
(config) # show cards
Box ID: 1
Slot Config Oper Status HW Type Product Code Serial Num HW Rev PowerReq PowerPriority
---------------------------------------------------------------------------------------------------
cc1 yes up HC3-Main-Board 132-00DR 1DR0-0029 1.0-00 N/A N/A
1 yes up PRT-HC3-C08Q08 132-00DW 1DX0-0001 A1-0 1
2 yes up PRT-HC3-C08Q08 132-00DW 1DX0-0001 A1-0 2
3 yes up SMT-HC3-C05 132-00DX 1DX0-0010 1.0-0 200 3
4 yes up PRT-HC3-X24 132-00DY 1DY0-0029 A1-0 60 4
Summary of Contents for GigaVUE-HC3
