Gigamon GigaVUE-HC3, Hardware Installation Manual

Page: 68 / 142

68 GigaVUE-HC3 Hardware Installation Guide
Removing GigaVUE-HC3 Modules
Use the following procedure to remove a GigaVUE-HC3 module from the node with the
power on. The procedure shuts down the ports on the module.
For other removal procedures, refer to Module Removal and Replacement Procedure
(Hot Removal) on page 69 .
I
MPORTANT
:
Hot removal of the module without following the listed steps can cause
system instability and require a reboot.
Before starting, make sure you are wearing an ESD-preventive wrist or ankle strap.
1.
Save map rules with the following CLI command:
(config) # config text generate active running save <name.txt>
Refer also to Backing Up Running Configuration on page 69 .
2.
To prepare the module for removal, press and hold the hot swap on/off button, then
release it. The LED will blink for a few seconds.
N
OTE
:
Pressing the on/off button is the same as issuing the following CLI command:
(config) # card slot <slot ID> down
3.
Wait for the module to shut down: RDY LED goes red; H/S LED goes solid blue.
4.
Slide the module out of the chassis and store it in a static-safe location.
5.
Insert the new module.
6.
Wait for the module to come back up: RDY LED goes green; H/S LED goes off.
7.
To verify the module is operationally up, issue the following two CLI commands:
(config) # show cards
(config) # show card slot <slot ID>
N
OTE
:
The output of the show cards command displays the operational status of the
module as up in the Oper Status field, as follows:
(config) # show cards
Slot Config Oper Status HW Type Product Code Serial Num HW Rev PowerReq PowerPriority
----------------------------------------------------------------------------------------------------
cc1 yes up HC3-Main-Board 132-00DR 1DR0-0010 1.0-00 N/A N/A
1 yes up SMT-HC3-C05 132-00DX 1DX0-002A 1.0-0 390 1
2 yes up SMT-HC3-C05 132-00DX 1DX0-0021 A1-0 390 2
3
yes up SMT-HC3-C05 132-00DX 1DX0-0020 A1-0 390 3
4 yes up PRT-HC3-X24 132-00DY 1DY0-0002 1.0-0 110 4
The processor on the SMT-HC3-C05 module may take a minute to become
operationally up. The
show card slot <slot ID> command displays the status of the
card as well as the status of the processor. Issue the show card slot <slot ID>
command to verify the processor state in the e1 State field. You may have to issue the
command a few times to watch the e1 State transition from down to up, as follows:
(config) # show card slot 3
Slot Config Oper Status HW Type e1 State e2 State
----------------------------------------------------------------
3 yes up SMT-HC3-C05
down down
(config) # show card slot 3
Slot Config Oper Status HW Type e1 State e2 State
----------------------------------------------------------------
3 yes up SMT-HC3-C05
up up