Gigamon GigaVUE-HC3, Hardware Installation Manual

Page: 128 / 142

128 GigaVUE-HC3 Hardware Installation Guide
8.
Run the jump-start script with the following command if it does not appear
automatically:
(config) # config jump-start
9.
Follow the prompts for the jump-start script.
10.
When the jump-start script has completed, run the following command to make
sure the node has an IP address:
(config) # show interface eth0
11.
Log into the node and run the show cards command. Refer to the following sample
output. Initially, the other cards will be down and only the control card will be
operationally up.
(config) # show cards
Box ID: 1
Slot Config Oper Status HW Type Product Code Serial Num HW Rev PowerReq
PowerPriority
---------------------------------------------------------------------------------------
cc1 yes up HC3-Main-Board 132-00DR 1DR0-0010 1.0-00 N/A N/A
1 yes down SMT-HC3-C05 132-00DX 1DX0-002A 1.0-0 200 1
2 yes down PRT-HC3-C08Q08 132-00DW 1DW0-0001 1.0-0 160 2
3 yes down PRT-HC3-X24 132-00DY 1DY0-0002 1.0-0 60 3
12.
Apply the previously saved configuration, using the following command:
(config) # configuration text fetch <http | https | ftp | tftp | scp | sftp>://<download URL>/<profilename.txt>
apply fail-continue verbose
13.
Verify that the information on the GigaVUE-HC3 matches the previously saved
configuration for chassis, cards, and traffic using the following CLI commands or
others, depending on your configuration:
(config) # show version
(config) # show chassis
(config) # show cards
(config) # show map
(config) # show map stats all
Node in Out-of-Band Cluster
The following procedure is to replace the control card on a GigaVUE-HC3 node in an
out-of-band cluster.
Use the show chassis command to record the GigaVUE-HC3 chassis box ID and the
show cluster config command to record the cluster ID, cluster name, cluster master
address vip, cluster master preference, and cluster interface.
To replace a control card in a GigaVUE-HC3 that is in an out-of-band cluster:
1.
On the cluster master node, backup the entire configuration on the cluster to a text
file.
(config) # configuration text generate active running upload <ftp | tftp | scp | sftp>://<upload URL>/
<profilename.txt>
2.
On the cluster master node, remove the configuration of the GigaVUE-HC3 node
from the cluster database. The commands may vary depending on your
configuration.