Extron electronics VNM EC 200, User Manual, Page: 19 / 242

Installation Overview
1. Power down and disconnect the VNM EC 200 and all devices.
2. Mount the controller (see Mounting on page 192).
3. Connect all devices to the controller (see Front Panel Features on page 7 and
Rear Panel Features on page 8).
4. Power on all devices.
5. Connect a control PC to the VNM EC 200 and configure the controller (see Accessing
the Web‑based User Interface on page 11).
6. Use the VNM EC 200 and the Web-based User Interface to configure all connected
devices.
EC 200 Rear Panel Reset
The
Reset
button on the rear panel (see figure 7
J
, on page 8) returns the EC 200
to default states depending on the reset mode. As shown in the reset mode summary
below, each reset affects different configurations and local files, resetting some to factory
condition and retaining others. The reset modes are used when the device IP address has
been forgotten, when improper operation is detected, and when it is desired to start a new
configuration.
To enter each reset mode, see the reset mode chart in figure 8.
NOTES:
• Each reset mode is a separate reset (not a continuation from mode 4 to mode 5).
•
For information on resetting the EC 200 using SIS commands, see
Resets
on
page 229 of the Command and Response Tables.
EC 200 Reset Mode Summary
Mode Activation Result Purpose and Notes
Reset All IP Settings
4
Hold in the
Reset
button for
about 12 seconds until the Reset
LED blinks four times (once at
3 seconds, twice at 6 seconds,
three times at 9 seconds, and
four times at 12 seconds).
Then, release and press
Reset
again within 1 second * .
Mode 4:
Sets the following back to default:
•
IP address (192.168.254.254).
•
Subnet mask (255.255.255.0).
•
Gateway IP address (192.168.254.1).
•
MTU (1500).
•
The Reset LED on the rear panel
of the unit flashes four times in
succession.
Mode 4 is used to reset IP
address information.
Equivalent to
E
1ZQQQ
}
SIS
command.
Reset to Factory Defaults
5
Hold in the
Reset
button for
about 15 seconds until the Reset
LED blinks five times (once at 3
seconds, twice at 6 seconds,
three times at 9 seconds four
times at 12 seconds, and five
times at 15 seconds.).
Then, release and press
Reset
again within 1 second
*
.
Mode 5:
Performs a complete reset to factory
defaults (except the firmware).
•
Resets all mode 4 items.
•
Resets all IP options.
•
Clears all user configuration settings.
•
The Reset LED on the rear panel
of the unit flashes four times in
succession.
Mode 5 is useful when it is
desired to start over with a new
configuration.
Equivalent to
E
ZQQQ
}
SIS
command.
NOTE:
*
Nothing happens if the momentary press does not occur within 1 second.
Figure 8. EC 200 Reset Modes
VNM EC 200 • Panels and Cabling 9