Extron electronics VNM EC 200, User Manual, Page: 237 / 242

Found New Hardware Wizard
Welcome to the Found New
Hardware Wizard
This Wizard helps you install software for:
If your hardware came with an installation CD
or floppy disk, insert it now.
What do you want the wizard to do?
Install the software automatically [Recommended]
Install from a list or specific location [Advanced]
Click Next to continue
Next > Cancel
Extron USB Device
1 1
2 2
Figure 186. Install the Software Automatically
4. Select Install the software automatically (Recommended)
(see figure 186,
1
).
NOTE: You do not need to insert an installation disc.
5. Click Next (
2
).
The PC locates the driver and installs it.
6.
When the Completed dialog opens, click Finish to close the wizard.
NOTE: The wizard opens only on the first occasion you connect the EC 200 to a
USB port. The wizard reopens only if you connect the EC 200 to a different USB
port or if you connect a different piece of equipment, requiring a different driver, to
the same USB port.
7. Configure the EC 200 as required.
Verbose Mode
Telnet connections can be used to monitor for changes that occur, such as SIS commands
from other Telnet sockets or serial port changes. For a Telnet session to receive change
notices, the Telnet session must be in verbose mode 1 or 3. In verbose mode 1 or 3, the
Telnet socket reports changes in messages that resemble SIS command responses.
Host-to-device Communications
The EC 200 accepts SIS (Simple Instruction Set) commands through the front panel
Configuration port (see
Front Panel Features
on page 7). SIS commands consist
of one or more characters per command field. They do not require special characters to
begin or end the command character sequence. Each response to an SIS command ends
with a carriage return and a line feed (CR/LF =
]
), which signals the end of the response
character string. A string is one or more characters.
EC 200-initiated Messages
The EC 200 initiates messages under specific conditions. No response is required from the
host. The EC 200-initiated messages are listed here (underlined).
]
© Copyright 2015, Extron Electronics, Enterprise Controller 200, V n.nn ,
60– xxxx-01
]
Day, DD MMM YYYY HH:MM:SS
]
V
n.nn
is the firmware version number.
VNM EC 200 • Reference Information 227