Extron electronics VNM EC 200, User Manual, Page: 132 / 242

Recorder Presets
Recorder presets are created similar to switching presets. Place an encoder device
into the
Preset
panel first, followed by a recorder channel or channels. Use the
Device Attributes
panel of a recorder to create or select a file directory, and select the
channels to record.
To Record a Channel
1. Create a preset with an encoder source and recorder channel (see figure 109,
1
).
1 1
Figure 109. Create a Preset
2. Select the record channel (see figure 110,
1
). The Device Attributes panel
populates with the configuration options appropriate for the recorder.
3. Create or select a directory (
2
) for the recording file (see Directory Management
Overview on page 110).
1 1
2 2
3 3
4 4
5 5
6 6
Figure 110. Select the Record Channel
4.
Enter a filename (
3
) for the recording (see
Recorder Directory and File
Management
on page 110).
5. Set the launch status (
4
) (see Launch Behavior on page 124).
6. Enter a description, if desired (
5
).
7. Select the remaining recording options (audio, whiteboard, and data) as needed (
6
).
8.
In the Preset panel, click Save (see
Saving Presets
on page 119).
The record preset is now complete.
9. Click Launch in the Preset List panel to begin the recording.
VNE250, HDCP, and Recording
It is not possible to record an HDCP encrypted source, however, this condition is not rules
checked in the preset manager (see
Preset Design – Connection Rules on page 100).
The source content is known only when the preset is launched and the recording starts.
If there is an attempt to record HDCP content, the system behaves as described for other
content. However, the recorded file is not created if the content is HDCP encrypted. This
condition is not flagged in the user interface.
VNM EC 200 • Preset Manager 122