Extron electronics VNM EC 200, User Manual, Page: 174 / 242

Setting the Role of the Primary EC 200
Use the following procedure to set the role of the redundant primary VNM EC 200 (see
Accessing the Web‑based User Interface on page 11).
1. Log into the redundant primary VNM EC 200 using the designated IP address and
click the Configuration tab.
The Configuration page opens (see figure 157,
1
).
1 1
4 4
3 3
2 2
Figure 157. Configuration Page — Redundant Primary Role Setup
2. Under Device Properties , click the Role link (see
2
).
3. From the
Device Mode
drop-down list, select
redundant_primary
(
3
).
NOTE: For information on the other device modes, see Role Page on page 22.
4. Click Apply Changes to save the configuration (
4
).
NOTES:
• The Web-based user interface returns to the Login page after saving the
configuration. This may take a few seconds.
•
After completing this procedure, the
Cluster Page
(see page 175) and
Node
Test Page
(see page 172) are available under a new Cluster Properties
folder on the left panel of the
Configuration
page.
VNM EC 200 • Dual (Redundant) Controller Configuration 164