Extron electronics VNM EC 200, User Manual, Page: 27 / 242

Configuring a Single EC 200 as the System Controller
This section details how to assign a single VNM EC 200 as the system controller. Before
proceeding, make sure the procedures detailed in
Single VNM EC 200 Configuration
on
page 13 are completed first.
NOTE: For information on how to configure dual VNM EC 200s as system controllers,
see Configuring Dual EC 200s as the System Controller on page 168.
Adding the VNM EC 200 to the Controller List
Use the following procedure to add the VNM EC 200 to the controller list. See Accessing
the Web‑based User Interface on page 11 for information on how to log in.
1. Click the Configuration tab.
The Configuration page opens (see figure 14,
1
).
Figure 14. Configuration Page — Adding Controllers to the Controller List
2. Click the
System config
link (see figure 14,
2
).
3. Click Add (
3
). The Peer Controller Address (Add IP) dialog box opens.
4. Enter the IP address of this VNM EC 200 and click OK (
4
).
NOTE: If necessary, clear the Controllers field. Highlight the displayed
IP addresses and click Delete .
5. Click Apply Changes (
5
) to save the configuration.
The VNM EC 200 restarts the user interface, and is assigned as the system controller.
VNM EC 200 • Single EC 200 Configuration 17