Extron electronics VNM EC 200, User Manual, Page: 35 / 242

Removing controllers from the Sources list
1. To remove a controller from the list, select a controller from the Sources list (see
figure 18 ,
2
on page 23).
2. Click the button (
2
in step 1 on the previous page) located below the Sources
list to remove the selected IP address.
3.
When finished, click Apply Changes located at the lower right corner of the Web page
(see
figure 18
,
5
).
Enabling clock synchronization
1. Add all of the controller IP addresses to the Sources list (see Adding controllers to
the Sources list on page 24). Do not add service (cluster) IP addresses.
2. Select (checked) the Enable Clock Synchronization check box (see figure 18 ,
2
on page 23 and below).
3. Click
Apply Changes
, located at the lower right corner of the Web page, to save the
setting.
4. Repeat this procedure for each controller device listed in the Sources list.
Disabling clock synchronization
1. Deselect the Enable Clock Synchronization check box (unchecked).
2. Click Apply Changes , located at the lower right corner of the Web page, to save the
setting.
Clock Settings Panel
This panel (see figure 18 ,
3
) is used to set the local time and date on the controller that is
logged into.
NOTES:
• Do not alter these fields if logged into the cluster IP address.
• If Enable Clock Synchronization is selected in the
Clock Synchronization panel, the values in this panel are dimmed.
• Set time — Enter the local time into this field or use the drop-down list button located
at the right side of this field to select the desired time.
The time is entered as follows.
•
Use the HH:MM:SS ( hours:minutes:seconds ) format based on the 24-hour
clock. For example, 08:25:00 or 20:35:10 .
•
Set date — Enter the current date into this field or use the calendar button located at
the right side of this field to open a calendar and select the desired date.
The date is entered as follows.
•
Use the MM/DD/YYYY ( month/day/year ) format. For example, 05/14/2012 .
VNM EC 200 • Advanced Controller Configuration 25