Accessing the Web-based User Interface
To access the Web-based user interface:
1.
Configure the network settings of a control PC so that it is compatible with the
VN-Matrix network and connect the control PC to the VN-Matrix network.
2.
Open a compatible Web browser running on the PC or laptop connected in step 1.
NOTE:
Configuring the Network Settings
for information on
how to configure the network settings of the VNM EC 200.
3.
In the address bar, enter the IP address of the EC 200 (default IP address is
192.168.254.254).
The login screen opens in the browser (see figure 9). The controller is security protected.
NOTE:
If the Web browser cannot access the Web-based user interface, the
security settings of the browser could require configuration.
Extron Electronics Matrix Enterprise Controller
Username:
Password:
Login
Figure 9.
VNM EC 200 Login Page
4.
Enter the appropriate username and password. Two profiles are available.
NOTES:
•
The procedures detailed use the administrator username and password
to configure the VNM EC 200. Extron recommends that the administrator
username and password be given only to those who require it. Other users
should use the guest login information to access the controller ensuring that
important configuration settings are not changed.
•
Username and password entries are case sensitive.
•
For information on how to change the password, see
Guest
— This profile hides the
Configuration
and
Format
Editor
tabs
prohibiting system changes to the VNM EC 200.
•
Guest username
— Default: user
•
Guest password
— By default, no password is required.
Administrator
— This profile allows full access to all of the Web-based user interface
configuration settings and is the default configuration profile.
•
Administrator username
— Default: admin
•
Administrator password
— Default: admin
VNM EC 200 • Controller Configuration and Operation
11
Summary of Contents for VNM EC 200
Page 6: ......