97
Adjustment
Room Controller KNX Touch One
• Status: 29.04.2014 • Errors excepted. Subject to technical changes.
Enter angle: To set the range in which shading shall be provided in exact numbers,
press the “from
0°
” or “to
360°
” and adjust the numeric values with the arrows keys
that appear.
Confirm your setting using the
OK
button.
Where the date and time are not available (
“
Please set the time!” in the display), the
shading elements are controlled using aperture, temperature, alarm messages and
time periods. The position of the sun is not taken into consideration.
Press the button in order to set the elevation at which the sun must be located in order
to actuate the drive.
Any height: If the solar elevation for blind actuation is not crucial, select
All elevations
(default setting).
Input an angle: In order to input a precise numeric elevation, change the numeric value
“
lower than
90
°” or
“
greater than
0
°” using the arrow buttons which appear.
The thickened section of the image shows the selected area.
Confirm your setting using the
OK
button.
Where the date and time are not available (
“
Please set the time!” in the display), the
blinds are controlled using aperture, temperature and alarm messages. The position of
the sun is not taken into consideration.
Press the button to set the travel position for automatic operation. Input the movement
position in % using the arrow buttons (0% = fully retracted, 100% = fully extended). Pre-
setting: 100%.
Confirm your setting using the
OK
button.
Press the button to set the shutter slat angle.
Fixed angle: if the slats should be opened to a fixed angle once the travel position has
been reached, leave the button position at
No
(do not track solar elevation). Input the
slat setting in % using the arrow buttons (0% = closed, 50% = horizontal,
100% = closed). Pre-setting: 75% (slightly open).
Tracking in accordance with position of sun: If the slats should be opened according to
the solar elevation, press the button so that this changes to
Yes
. You can now adjust
the slat opening to the changing angle of the sun. Use the arrow buttons beside the %
values to do this.
only if blinds are used dependent on brightness
Sun elevation
Movement position
Slat position
Only for blinds!
